RadioLink Electronic Limited
3
MODE 2
Note
If it’s the transmitter from other brands used with RadioLink F121 Pro, make sure that the receiver should
be SBUS signal output supported. Once the receiver is installed on the mini drone, the phase of the throttle
should be reversed while the other three channels normal and the CH5 should be set with a 3-way switch to
change the flight mode and the CH7 set a switch (a 2-way switch or a 3-way switch is OK) for arm or disarm.
Servo phases of transmitters from other brands should be set according to the actual situation.
2.3 F121 Pro
Assembled as building block makes the RC students exercise their DIY ability and free from lengthy mobile
games. Learning knowledge of science and technology when assembling, setting parameters and flight.
2.4 Joysticks & Flight Movements
A. Throttle: Rise/ Descend/Hover
65mm prop(CW)
8520 motor(CCW)
Prop protector
Motor
Protector
65mm prop
(CCW)
8520 motor
(CW)
Prop
protector
Motor
protector
65mm prop(CW)
8520 motor(CCW)
Prop protector
Motor protector
65mm prop(CCW)
8520 motor(CW)
Prop protector
Motor protector
Camera
Camera protector
F121 flight controller
Fiber
Frame
Cable(receiver& flight controller)
Battery frame
R8SM receiver
PA1.7*8
Screws
F121 cover
* CW: Clockwise
* CCW: Counter Clockwise
*
There are screws packed with F121 Pro to ensure the firm installation of the propeller’s protector
to the F121 Pro frame even with collision. Pilots can fix them on as necessary.
