CHARGING the FLIGHT BATTERY
Plug charger into USB port or AC adapter (DIDP1125 not included)
as shown and connect the battery. The red LED will flash slowly
while the battery is charging. The LED will be steady when the
battery is fully charged.
•
NEVER
leave the battery unattended while charging.
•
DO NOT
allow the USB port to power down while the charger
is connected to the battery.
•
ALWAYS
unplug the charger from the USB port and the
battery when charging is complete.
• The battery connector will only fit in one way.
LINKING
Your KODO comes with a Power-On failsafe. This is designed to
ensure that the motors will not start until the KODO has detected
the controller.
1. Turn on the controller with the throttle
at its lowest position.
2. Connect the battery to the Kodo HD
and place it on a level surface. Listen
for two beeps. The red LED at the
back of the quadcopter will start
fl ashing slowly.
3. Move the throttle to its highest position. Listen for a beep
4. Move the throttle back to its lowest position. Listen for three
beeps.
The Kodo’s motors are now armed and the quad is ready to fl y. The
red LED on the Kodo HD will become steady.
READ THESE
READ THESE
INSTRUCTIONS
INSTRUCTIONS
BEFORE
BEFORE
FLYING !
FLYING !
• Do not mix old and new batteries
• Do not mix alkaline, standard, or
rechargeable batteries.
CONTROLLER SETUP
Push down on the left stick to
change the sensitivity
of the controls.
SENSITIVITY ADJUSTMENT
Lowest (Default)
Moderate
Maximum
x2
x3
Remove the screw on
the battery compartment
cover. Take the cover off
and insert 2 AAA batteries.
Replace cover securing
with the screw.
NOTE:
For Mode 1 operation, slide the mode switch to the MD1 position
and flip the controller so the throttle is on the right side.
Mode 1/ Mode 2
Switch
LED
Video
Button
Aileron
Trim
Throttle/Rudder
Stick
Throttle
Trim
ON/OFF Elevator
Trim
Aileron/Elevator
Stick
Rudder
Trim
Photo
Button
™
KODO
™
Drone
Controller
2G Memory Card
USB Card
Reader
USB
Charger
Spare Blades
(2 black, 2 yellow)
Blade Guards
AAA Batteries
BC
