background image

HOW to FLY

Basic Flight   

Advance the throttle slowly until your Kodo HD rises into the air. 

The controls are very sensitive and small stick movements should be used to the 

control the quadcopter. If you get into trouble and see that the Kodo HD is going to 
crash, move the throttle to its lowest position immediately.

The LED on the Kodo HD will flash slowly when the battery voltage is getting 

low. 

Land as soon as possible and unplug the battery.

 Always recharge the 

battery or batteries before storing the Kodo HD.

Flips  

Push down on the right stick and release it when the controller beeps. 

Move the right stick in any direction and release it when the Kodo starts to flip.

The red LED on the Kodo HD will flash when the battery voltage is getting low. Land 

as soon as possible and charge the battery.  The battery must be charged before 
it is stored.  The battery must not be connected to the Kodo HD or the charger 
when stored.

A

A

C

C

D

D

B

B

E

CORRECTING DRIFT

It is normal for the KODO to drift slightly. However, if it drifts in any direction 
consistently, press the trim button that is opposite the movement as many times 
as needed to eliminate the drift.

CAMERA OPERATION

Press the photo button to capture a 
photo.  

Press the video button to start a video.  

The video button must be pressed again to stop and save the video on the card. 
The photo button will not operate while the camera is recording a video.

Only insert and remove the memory card when the battery is not connected to the 
Kodo HD. When the memory card is installed, there will be a steady blue LED just 

above the card slot. 

The camera lens angle can be adjusted from straight ahead to 70 degrees down. 

To view the photos or videos, remove the memory card and install it in the card 

reader. Install the card reader in a USB port on your computer 

BLADE GUARD REPLACEMENT

1.   Carefully pry off the blade using a flat 

head screwdriver. 

NOTE:

 Do one corner 

at a time so you don’t accidentally mix 
up the blades.

2.  Pull blade guard up 

and off the motor 
housing. Install 
the new guard 
and replace the 
rotor blade.

Photo Button

Video Button

Use Left Trim

Reviews: