CHARGING the FLIGHT BATTERY
Plug charger into USB port or AC adapter (DIDP1125 not included)
as shown and connect the battery. The red LED will flash slowly
while the battery is charging. The LED will be steady when the
battery is fully charged.
•
NEVER
leave the battery unattended while charging.
•
DO NOT
allow the USB port to power down while the charger
is connected to the battery.
•
ALWAYS
unplug the charger from the USB port and the
battery when charging is complete.
• The battery connector will only fit in one way.
SETUP
Your KODO FPV comes with a Power-On Fail-Safe. This ensures that
the motors will not start until the KODO has detected the controller.
1. Turn on the controller with the throttle
at its lowest position.
2. Connect the battery to the KODO
FPV and place it on a level surface.
Listen for two beeps. The red LED at
the back of the quadcopter will start
fl ashing slowly.
3. Move the throttle to its highest position. Listen for a beep.
4. Move the throttle back to its lowest position. Listen for three
beeps.
The KODO FPV’s motors are now armed and the quad is ready to
fl y. The red LED on the KODO FPV will become steady.
READ THESE
READ THESE
INSTRUCTIONS
INSTRUCTIONS
BEFORE
BEFORE
FLYING !
FLYING !
• Do not mix old and new batteries.
• Do not mix alkaline, standard, or
rechargeable batteries.
CONTROLLER
Push down on the left stick to
change the sensitivity
of the controls.
SENSITIVITY ADJUSTMENT
Lowest (Default)
Moderate
Maximum
x2
x3
Remove the screw on
the battery compartment
cover. Take the cover off
and insert 4 AAA batteries.
Replace cover, securing
with the screw.
Video
Button
Elevator
Trim
Throttle/Rudder
Stick
Rudder
Trim
ON/OFF
Aileron
Trim
Aileron/Elevator
Stick
Throttle
Trim
Phone Holder
Picture
Button
™
KODO
™
Drone
Controller
FPV Headset
Screwdriver
USB
Charger
Spare Blades
(2 black, 2 red)
Flight Battery
4 AAA Batteries
