RadioLink Electronic Ltd
www.radiolink.com
19
3.
Press Start and SET button at the same time. Then power on the charger and enter the calibration
setting page, as shown in the picture below:
4. The calibration of the CB86-PLUS charger includes power supply voltage calibration and battery
voltage calibration. Calibrate the power supply voltage first, and then calibrate the battery voltage.
Please refer to the following calibration steps:
1
Pwr
：
power supply voltage calibration
Press SET button to adjust the current power supply voltage automatically. If the value is different
from the actual power supply voltage you measured, press "+/
▲
" or "-/
▼
" buttons to make fine
adjustments until the power supply voltage displayed is the same with the power supply voltage
measured.
After the adjustment, press Start button to confirm the calibration. The word OK will appear next to
Power Calibration, indicating that the power supply voltage calibration is complete and the battery
voltage calibration can be performed.
2
Bat
：
battery voltage calibration
Connect the battery to any port of the charger first, and then press SET button to adjust the current
battery voltage automatically. If the value is different from the actual battery voltage you measured,
