Radiocrafts
Embedded Wireless Solutions
RC1xx0 / 2x00DK
2008 Radiocrafts AS RC1xx0 / 2x00DK Demonstration Kit version 3.0 User Manual (rev. 3.1)
Page 4 of 14
Demonstration Board
The Demonstration Board contains a serial port driver circuit for RS232 and the 9-pin D-Sub
connector, buttons (CONFIG, TXEN, RXEN, RESET), voltage regulator, configuration
jumpers and connectors to make it easy to interface the onboard module with various test
equipment or the host used in an application. Not all components are needed in an actual
application. Please see the datasheet for each specific module for a typical application circuit.
The Demonstration Board comes in different versions, equipped with the different variants of
the modules. Among the frequencies supported are 433 MHz, 868 MHz, 915 MHz and 2.45
GHz. For each frequency there exist narrowband versions (RC12x0-series) and wideband
versions (RC10x0-series and RC2x00). This covers the most used frequency bands, the 433
MHz band in Europe and the US, the 868 MHz band in Europe, the 902-928 MHz band in the
US and the 2 450 MHz band world wide. The actual module mounted can be seen on the
marking on the module itself.
Figure 1: RC1xx0/RC2x00 Demonstration Board
Antenna connector
RESET
Supply voltage
terminal block
Digital I/O
connector
RX232 D-Sub
DC jack
RC1xx0 or
RC2x00
TXEN
RXEN
CONFIG
