10
Drone swerves or moves erratically before taking off
• The gyroscope inside your drone needs calibrating: Do the following:
1.
With your drone and remote control switched on and paired, place the
drone on level ground.
2.
Move the throttle all the way down.
3.
Move the steering forward and hold this position for a few seconds until
the drone LEDs start to blink.
4.
Release the steering. The drone LEDs light steadily, indicating successful
calibration. You are now ready for takeoff.
•
See
“trim Your Drone"
to fine tune hovering and movement to further
improve control of your drone after calibration.
FCC Information
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• onnect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
If you cannot eliminate the interference, the FCC requires that you stop using your
equipment. Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
Limited Warranty
Go to www.radioshack.com/help for details.
RadioShack Customer Relations
300 RadioShack Circle, Fort Worth, TX 76102
www.radioshack.com
© 2016 General Wireless Operations Inc.
All rights reserved. RadioShack is a registered trademark
used by General Wireless Operations Inc. dba RadioShack
Printed
in China
06A16
6001432
6001432_PM_En.indd 10
6/21/2016 12:04:23 PM
