7
Installation
Completing the Connections
After you have securely made all other
connections, plug the 14-pin connector
into the stereo's 14-pin wiring socket.
Then reconnect the cable to the vehi-
cle's negative (–) battery terminal.
TESTING THE
CONNECTIONS
Turn on your vehicle's ignition, install the
stereo's faceplate, and test the stereo.
If the stereo does not work, immediate-
ly disconnect your vehicle battery's
negative (–) terminal. Then recheck
your connections.
After you test the stereo and verify that
everything works, make sure the con-
nections are marked or identified. Then
follow the instructions in “Mounting the
Stereo.”
MOUNTING THE STEREO
Be sure you test the stereo first and ver-
ify that it works properly.
Follow these steps to mount the stereo.
1. Disconnect the cable from the vehi-
cle battery's negative (–) terminal.
2. Temporarily disconnect the wire har-
ness and antenna.
3. Lift the top of the outer trim ring,
then pull it straight out to remove it.
4. Insert both of the supplied keys into
the slots at the middle left and right
sides of the stereo until they lock
into place, then slide the sleeve off
of the stereo.
14-Pin
Wiring Socket
14-Pin
Connector
Wire Harness
Sleeve
Keys
12-2117.fm Page 7 Thursday, February 24, 2000 11:21 AM
