17
Operation
entry. You can add more pause entries for a
longer pause.
Reviewing Memory Numbers
To review your memory numbers, press
MEM
. The list of memory location numbers
(01–20) appears with the name stored with
each number (or
2C[ceho
2C[ceho
2C[ceho
2C[cehoddddd4
d4
d4
d4
if you did not
store a name).
To see the stored phone numbers, press
#
/
7
7
7
7
. An arrow to the right of the number
means it is longer than 13 digits. Press
#
/
7
7
7
7
again to see the rest of the number. Repeat-
edly press
TONE
/
6
6
6
6
/
to return to the
name display.
To exit the memory number list, press
MEM
.
To see a stored name and phone number at
the same time, press
SELECT
/
CH
when the
cursor is by a memory location number. To
exit this display, hold down
DEL
until the dis-
play clears.
Dialing a Memory Number
To dial a number stored in memory, lift the
handset and press
MEM
. The list of memory
location numbers appears. Choose a memo-
ry location (01–20) by pressing a number or
by repeatedly pressing
VOL
/
CID
8
8
8
8
or
9
9
9
9
,
then press
TALK
.
You can also dial a memory number after
pressing
TALK
. Press
MEM
(the display does
not change but the phone’s memory recall
activates) then enter a memory location
number.
Chain-Dialing Service Numbers
For quick recall of numbers for special ser-
vices (such as bank-by-phone), store each
group of numbers in its own memory loca-
tion. Dial the service’s main number first.
Then, at the appropriate place in the call,
press
MEM
and enter the number for the lo-
cation where the additional information is
stored.
Testing Stored
Emergency Numbers
If you store an emergency service’s number
(police department, fire department, ambu-
lance) and you choose to test the stored
number, make the test call during the late
evening or early morning hours to avoid peak
demand periods. Also, remain on the line to
explain the reason for your call.
USING A HEADSET
You can make or answer calls with hands-
free convenience using an optional headset
that has a
3
/
32
-inch (2.5-mm) plug. Contact
your local RadioShack store for a suitable
headset.
To connect the headset, pull open the rubber
cover marked
on the side of the handset,
then insert the headset’s plug into the jack.
When you finish using the headset, discon-
nect it from the handset and close the rubber
cover to protect the jack.
Notes:
• Connecting a headset disconnects the
handset’s earpiece and microphone.
•
VOL
/
CID
8
8
8
8
or
9
9
9
9
on the handset also
controls the headset’s volume.
• If you place the handset on the base to
recharge it while the headset is con-
nected, be sure the handset seats prop-
erly.
• With a headset connected, you can
make or answer calls as usual using the
keys on the handset.
