Digital BUS-WATCH
®
11
Radio Engineering Industries, Inc.
640333
Rev 0 -- 1/1/2006
System Installation
System Wiring
Note:
All cables should be hidden from view.
For the basic system (shown in Figure 5), there are five cables, one power (P/N 512002
– 16 Feet, or 512001 – 35 Feet) and 4 camera (P/N 510781 or any different length
cable). For external record indication, and alarm/event marking, the Record Indicator /
Event Mark Button Harness (P/N 511986) is available (shown in Figure 6). The GPS
Harness (P/N 710010) is used for satellite location and movement information (shown in
Figure 7). For additional vehicle monitoring, the BUS-WATCH®
IV
Vehicle Sensor
Options harness (P/N 512008) is available (shown in Figure 8)
Connect the camera(s) using cable P/N 510781, or equivalent. There is no specific
orientation for camera cables to be installed. If multiple types of cameras are installed
in a single system, be careful to note which cameras are located where. Use lenses
with more magnification (8mm) for to bring objects closer that are far away. Use lenses
with less magnification (4mm) for wide angle viewing.
Connect power using cable P/N 512002, or equivalent. The black wire connects to the
negative terminal of the battery. The green wire (labeled 12V Battery) connects directly
to the positive terminal of the battery.
The green wire should be fused at 10 Amps if
using a 7 or more camera system with a Quad Video Processor (P/Ns 700483 or
700848).
See Figure 5.
Connect any Quad Video Processors (P/Ns 700483 or 700848)
or Camera Switching
Devices (P/N 700462 or 710030) as needed for multiple camera systems.
IF THE SYSTEM OPERATES IN THE MANUAL RECORD MODE, connect the red wire
(labeled 12V SW), to the switched side of the ignition switch. The red wire should be
fused at 1 A. The red wire is ignored if the system is in TIMER record mode.
WARNING
DISCONNECT VEHICLE BATTERY VOLTAGE BEFORE
INSTALLING SYSTEM WIRING
WARNING
DISCONNECT POWER TO THE DIGITAL BUS-WATCH®
IV
BEFORE JUMP STARTING VEHICLE
