Digital BUS-WATCH
®
R1001 / R4001
Speedometer Setup
Figure 75: Event Setup – Sensor – Speedometer Screen Shot
The SPEEDOMETER subsection of the SENSOR section, shown in Figure 75
above, is used to set speed thresholds and to calibrate the Speedometer Readings coming
out of the Vehicle Sensor Options Harness as shown in Figure 15 on Page 24.
SOURCE:
VEHICLE
or
GPS
SPEED
UNIT:
MPH
or
KM/H
SPEED
CAL:
For
calibration
of analog speedometer pulses
SPD:
The target speed of the bus (i.e. 030 MPH)
P/S:
The number of Pulses/Second that the DVR is counting.
CALIBRATE:
Press
ENTER
when vehicle is going the set speed.
THRESHOLD:
LOW and HIGH speed limits.
ENABLE:
ON or OFF
SPEED:
Usually set to 0 for tagging all the stops, and set to the
highest legal speed limit the bus will travel on (i.e. 50, 60,
75 MPH)
ALARM:
YES or NO. Alarm set to YES will log file in Event Search.
Page 74 of 96
Radio Engineering Industries, Inc.
640370 -- Rev 0 -- 8/17/2007
