Digital BUS-WATCH
®
HDx00
Page 22 of 85
Radio Engineering Industries, Inc.
640430 -- Rev 0 -- 1/12/2012
Long Term Storage
Although the Digital BUS-WATCH® systems draw very little current in the
stand-by mode, if the systems are installed but not used for an extended period of time
(longer than 2 weeks) it is recommended that the power be disconnected from the
DVR to avoid draining the vehicle battery. The DVR internal clock will hold time and
date for up to 10 years sitting on a shelf, and the daylight saving time functions will
kick in upon re-initialization when power is applied.
Installation
System Wiring – Power and Camera Cables
Note:
All cables should be hidden from view.
For the basic system, there are five cables, one power (P/N 512002 – 16
Feet, or 512001 – 35 Feet) and 4 cameras (P/N 510993 or any different length
cable). For external record indication and alarm/event marking, the record indicator
/ event mark button harness (P/N 511986) is available (shown in Figure 12 on Page
24). The GPS harness (P/N 710144) is used for satellite location and movement
information. For additional vehicle monitoring, the BUS-WATCH® vehicle sensor
options harness (P/N 512008) is available.
WARNING
DISCONNECT VEHICLE BATTERY VOLTAGE BEFORE INSTALLING
System WIRING
WARNING
DISCONNECT POWER TO THE DIGITAL BUS-WATCH® BEFORE
JUMP STARTING VEHICLE
WARNING
INSTALL DVR HORIZONTALLY. USE EXTERNAL SHOCK AND
VIBRATION DAMPENING IF NEEDED.