! Securely glue together If coming
off during fly, you lose
control of your air plane.
Full the elevator out of the
horizontal stabilizer.
Cut away only
the film both
side
Cut away only
the film both side
A B
Remove the horizontal stabilizer from the fuselage.
Using the sharp hobby knife, carefully cut away the
covering inside the lines which were marked above.
Spread epoxy (30 minute) onto the top and
bottom of the horizontal stabilizer along the
area where the covering was removed and
to the fuselage where the horizontal stabilizer
mounts.
Install the horizontal stabilizer into the fuselage
and adust the alignment as described in steep
5B.
Allow the epoxy to cure before proceeding to
next step.
Trial fit the horizontal stabilizer in place. Check the alignment of the
horizontal stabilizer.
When you are satisfied with the alignment,
use a pencil to trace around the top and
bottom of the stabilizer where it meets the
fuselage.
5A
5B
5
5C
5C
5D
5E
B
B’
B=B’
Do the same way with the vertical stabilizer.
If the parts will join, but with a gaps, sand or trim the parts a little at
a time until the parts meet exactly with no gaps.
* WARNING: When removing any covering from the airframe,
please ensure that you secure the cut edge with CA or similar
cement. This will ensure the covering remain tight.