Radijator Inženjering d.o.o, 36000 Kraljevo, Živojina Lazića - Solunca br.6, Srbija
tel. +381 36 399 140, fax. +381 36 399 150, http://www.radijator.rs
e-mail: [email protected]
84
Display menu
Brightness
Menu used to regulate the display brightness.
Minimum Light
Menu used to regulate the lighting of the display when the display is not used.
Sound
It allows to enable or disable the acoustic alarm of the keyboard.
Keyboard Address
This menu is password-protected and no changes should be made in it.
Node list
This menu shows communication address, FW code, FW version, etc. Data are not
modifiable.
System menu
A password is needed for entering the menu. Settings in the System menu are
intended for professionals.
7.2. Functioning states of the system
-
Off – The system is off;
-
Check Up – check-up whether everything is fine with the system and whether the ignition may
safely start;
-
Ignition;
-
Stabilization - Operating modality between Ignition and Run mode. Its role is to ensure the stable
work of the boiler in the working mode.
-
Recovery Ignition – The operating mode is activated during ignition only if the system had not
been regularly turned off for some reason (cable unplugged, longer power cuts, etc.);
-
Run mode – Normal operating modality, the boiler has still not reached the set temperature;
-
Modulation – Normal operating modality, the boiler has reached the set temperature;
-
Standby – Boiler is in the standby modality, ready to start. It is usually used in combination with
room thermostat.
-
Safety – safety operating modality. The boiler enters this modality only if the flue gases
temperature or water temperature are too high;
-
Extinguishing – Boiler is turning off;
-
Block – Automation system has detected irregularities in the work of the system.
7.3. Door sensor
-
Sensor on the boiler door is a standard part of the boiler equipment. The sensor detects whether
the door of the boiler is open and sends a signal to the automation system. In case you open the
door while the boiler is working, the automation system of the boiler will do the following:
o
Stop the system for feeding pellets;
o
Fan speed will be at its maximum;
o
The message port/door will appear on the display.
-
After shutting the door, the boiler will continue its normal work.
-
Automation system displays a message port/door even in the OFF mode (i.e. when the boiler is
turned off).
These precaution measures prevent the return of the flame through the boiler door and guarantee safety to
the user.
