Host (End Product) Labeling Requirements
To maintain compliance, the end product hosting the WiFiHU2 module must be properly
labeled to identify that this module is installed. This transmitter module is authorized
only when used in devices where the antenna is installed such that 20 cm is maintained
etween the antenna and users. The final end prod ct must have a label located in a
isible area with the following information:
ble and intact on the
evice in all normal conditions of use throughout the device’s expected lifetime. These
quirements may be met either by a separate label or nameplate permanently attached to
e device or by permanently imprinting or impressing the label directly onto the device.
perating instructions for satisfying RF Exposure compliance. The end user should NOT
e provided any instructions on how to remove or install the device. The users manual for
nd users must include the following information in a prominent location.
b
u
v
Contains Transmitter
Module
Model:
XXXXXXX
FCC ID:
K7T- WIFIHU2
IC:
2377A- WIFIHU2
The XXXXXXX reflects the correct model installed into the host equipment: The
models are WiFiHU2-a, WiFiHU2-c, WiFiHU2-a-1-NE, or WiFiHU2-c-1-NE
The label shall be securely affixed to a permanently attached part of the device, in a
location where it is visible or easily accessible to the user, and shall not be readily
detachable. The label shall be sufficiently durable to remain fully legi
d
re
th
The label text shall be legible without the aid of magnification, but is not required to be
larger than 8-point font size.
End User Information:
This equipment complies with FCC radiation exposure
imits set forth for an uncontrolled environment. End users must follow the specific
l
o
b
e
14
