Quick Start Guide
Installation and Operation Manual
2
Operating FOM-E1/T1
FOM-E1/T1 Ver. 2.0
Connecting the Cables
To connect cables:
1. Connect the E1/T1 electrical interface.
2. Connect the fiber optic interface.
3. Connect the power cable (first to the modem, then to the mains).
Operation starts when the power is applied to the rear panel power
connector.
2. Operating
FOM-E1/T1
1. Check that SW1 of the DIP switch is set to OFF.
2. Verify LED status. All the LED indicators should be OFF, except for the PWR
indicator.
3. If there is an indication of a malfunction or fault, run a diagnostic test.
