radiance 7201111, Instruction Manual

Page: 5 / 26

RAD/03
SETTING UP FOLLOW SPOT
THE RADIANCE FOLLOW SPOT is shipped in sections which must be assembled.
The yoke and spigot (truss pin) are included with the head assembly; the tripod floor stand is a factory-
supplied option.
THE SPIGOT is a standard 28mm (1-1/8 inch) diameter for truss mounting. The spigot
will also seat into the top of the optional tripod base stand. Height of the unit may be determined by the
user, but when adjusting the tripod base, make certain the unit remains stable. Setting the tripod base
to an extreme operating height contributes to making the spotlight assembly topheavy and unsteady.
THE RADIANCE COLOR BOOMERANG mounts to the front of the unit on two
studs (see Figure 6, Item 15) aligning to keyhole slots at the top of the housing, and is attached to the
spotlight at the bottom of the housing by a thumbscrew. Make certain the thumbscrew is secured.
PROVISION IS MADE for “stowing” color frames for shipment. When stowed, the
color frames are protected from breakage or other damage caused by transporting the spotlight. To
enable operation of the color boomerang, detach the lower thumbscrew securing the hinged portion
of the boomerang housing and fold the panels upward. This allows the color frames to drop into a
“deployed” position for normal operation. An upper thumbscrew allows locking the hinged panels in the
upper position. To again stow the color frames for transport, raise all six color frames to their engaged
position, loosen the upper lockscrew, unfold the boomerang housing, and secure in the lower position.
CHECK THE EQUIPMENT DATA PLATE to determine voltage and current requirements;
verify correct plug and receptacle configuration. DO NOT connect the power cord to the AC line until
completing the installation of the metal halide lamp.
“Stowed” “Deployed”
Housing
Lockscrew
Mounting
Thumbscrew