![background image](http://html1.mh-extra.com/html/radialight/windy/windy_installation-and-operating-manual_3246765026.webp)
26
SELECTION BUTTONS
Selection buttons are used within the menus to display and/or set the several customizable parameters as shown in
the various sections of this manual.
You can check the set Comfort temperature at any time by pressing a single time the
or
key. A further pression
will modify the set temperature.
Note
: The temperature measured by the inner sensor of the product is representative of the ambient temperature
nearby it and it may differ from the temperature measured using other instruments in other areas of the room. That
difference may depend on many factors including, for example:
- the installation position: some areas of the room may be affected by drafts or hot air sacs that modify the sensor
measurement;
- an external wall fixation: it may imply a temperature measurement lower than the real room temperature;
- an excessive towels load on the support bar may obstruct the airflow. As a result the sensor may measure a tempe
-
rature higher than the real room temperature;
- unstable conditions: any evaluation must be done in stable working conditions. For this purpose Comfort temperature
should be changed only 60min after a previous change. In fact, it is not possible to evaluate if the room temperatu-
re is correctly maintained by the product when the Comfort temperature gets repeatedly changed in a short time.
If the difference between set temperature and room temperature is detected in stable working conditions, measure the
difference and then increase or decrease the comfort temperature on the product of the exact measured difference
value.
OK BUTTON
The OK button is used in the various menus to confirm the chosen settings.
BOOST BUTTON
The Boost button allows to activate the timed operation for 15 minutes at maximum power without the thermostat
control. During this operation the display shows alternately the word "BooS" and the remaining time. At the end of this
forced operation, the fan heater returns to the previous operating mode.
Summary of Contents for WINDY
