7
In humid rooms, bathrooms or kitchens, this connection block must be installed at least 25 cm from the floor.
The electrical connection must also include the use of a 2-pole switch with a contact opening distance of at least
3 mm.
5. Cable storage
While the product is not in use, you can store the cable pushing it into the base of the product.
Note that while the product is in operation, the cable must always be completely pulled out.
6. Use of the heater
See picture 5
6.1 Version with switch and thermostat
The heater has 2 knobs controlling the switch and the thermostat.
The switch knob has 5 positions, allowing to select the desired power setting.
Starting from the “
” position, turn the thermostat knob clockwise until you hear a "click”: the appliance starts
working at the desired power setting.
The thermostat maintains the desired room temperature switching on and off automatically the appliance. The
more the knob is turned clockwise, the higher is the maintained temperature. Maximum thermostat setting
corresponds at about 30°C; “
” position corresponds to approximately 5°C.
For correct use of the thermostat , see section 6.3.
6.2 Model with thermostat and 60' timer
The heater has 2 knobs controlling the timer and the thermostat.
Turn the timer knob clockwise to select the working time you prefer from 5 to 60'. The heater starts working at
full power (2000W) and thermostat setting doesn’t influence the functioning;
After the selected period the heater will automatically turn to mid power (1000W), thermostatically controlled
according to the thermostat setting. For the use of the thermostat see section 6.3.
When the heater is working under timer control at full power, the thermostat doesn't control the room
temperature. In this condition, do not use the heater in small rooms when they are occupied by persons not
capable of leaving the room on their own, unless constant supervision is provided.
6.3 Use of the thermostat
In a room where the temperature is too high (more than 30°C), it is normal that the thermostat will not switch on
the heater.
In a room where the temperature is too low (around 5°C or even less) it is also normal that the thermostat will
keep the appliance working until the temperature gets higher.
To select the right thermostat position we suggest you to
-
turn the thermostat in maximum position (clockwise) and leave the appliance working until the comfortable
temperature is reached;
-
turn the knob anti clockwise until you hear a "click" and the appliance stops;
-
turn clockwise again the knob (just a little): in this position the thermostat will maintain the comfortable
temperature you have selected.
7. Safety in the event of the product not functioning normally
In the event of overheating, the safety system will automatically turn off the heating elements and the motor. If
this happens:
-
switch off the fan heater using the main switch;
-
remove the cause of overheating (i.e. obstacles in front of the air inlet or air outlet grilles, unusual
accumulations of dirt, etc);
-
let the heater cool down for 15/20 minutes;
-
switch on the fan heater and check it is functioning properly.
If you notice irregular operation, damage to the heating element or to the structure of the appliance, disconnect
the product from the mains power supply and contact your technical assistance center or dealer.
