6
WARNING: Do not use this heater in small rooms when they
are occupied by persons not capable of leaving the room on their
own, unless constant supervision is provided
WARNING: Operate this heater at a distance of 1 m from
textile, curtains and/or any flammable materials.
3. Safe positioning
Only ever use the appliance in an upright position;
When the product is wall mounted, make sure that the minimum distances reported in pictures 1 and 2 are
respected. Do not place the heater so that the air flow blows directly towards the wall.
As the heater is a class 2 product, earth connection is not required.
The heater has an IPX1 protection level against water and, if wall mounted may be installed in bathrooms. In any
case you have to respect the national installation standard and safety requirements valid in your State.
Never install/use this appliance in the Zones 0, 1 or 2 illustrated in picture 3:
On no account must any switch / button be accessible by people
in the shower or in the bathtub.
4. Wall mounting
After carefully reading section 3, proceed with installation following the sequence shown in picture 4.
To hang on the product proceed as follows:
-
Lay the base of the product on the base of the wall bracket coupling the plastic ribs created to make the
lodging easier;
-
Push a little bit the product downwards and move the upper side of the product near the bracket;
-
Check that the upper holed rib of the bracket fits the dedicated pivot created on the back grid of the heater.
Moderately shake the heater after installation to be sure it is correctly fixed.
To release the product from the bracket proceed as follows:
-
Use your hand to push downwards the upper rib of the bracket as much as necessary to release the product by
pulling it on the top.
-
Once the product has been unlocked on the upper side just pull it upwards to release it from its base.
IMPORTANT FOR FRANCE:
If the product is wall mounted, the electrical connection must be made according to the enclosed drawing,
cutting the cable and using a connection block between the product cable and the electricity supply.
