Radialight MANTRA 15, Installation And Operating Manual, Page: 12 / 20

12
• WARNING! When the knobs are at the maximum position do not turn them further clockwise.
• When the product is working, slight undulations may occur on the surface of the heating element inside the pro -
duct. This is completely normal and does not affect correct functioning of the equipment or its reliability over time.
Using the thermostat
• In a room in which the temperature exceeds 35°C it is normal that, even when turned to maximum, the product
does not switch on.
• On the contrary, in a room in which the temperature is too low (below 5°C) it is normal that, even when turned to
minimum, the thermostat will keep the equipment switched on all the time.
• To make the best thermostat setting, we recommend the following:
- Put the thermostat on maximum and allow the equipment to run until a comfortable temperature is reached.
- Then turn the thermostat knob anticlockwise until you hear a “click”, and the equipment switches off.
- Then turn the thermostat knob clockwise again (only a little).
- In this position the thermostat will maintain the ambient temperature you have chosen.
4. s
afety in case of abnormal oPeration
• If the product overheats the protection system will automatically deactivate the heating elements and switch off
the equipment. If this happens:
- Turn the thermostat knob clockwise to check that the thermostat has not simply switched off the equipment
because a high ambient temperature has been reached. If the product does not start working normally
again:
- Switch off the equipment
- Remove whatever is causing the overheating (e.g. obstructions at the air intake or air outlet grilles).
- Allow the product to cool for 15 – 20 minutes.
- Switch the product on again.
• If you notice irregular operation, damage to the heating element or to the structure of the appliance, disconnect
the product from the mains power supply and contact your technical assistance center or dealer.
5. m
aintenance
• This product does not require specific maintenance.
• Every six months we suggest removing any dust that has accumulated on the coil using a vacuum cleaner.
• If you need any assistance, contact an authorised assistance centre.
• If you have to change the power supply cable, remember that you have to use an 3x1mm
2
H05RR-F model cable.
6. l
egal notice
Environment and recycling
Please help us to protect the environment by disposing of the packaging in accordance with the national
regulations for waste processing.
Recycling of obsolete appliances
Appliances with this label must not be disposed off with the general waste. They must be
collected separately and disposed off according to local regulations.