9
Owner’s Manual:
05995
1784779 Rev X
ECO 18-0034
July 2018
www.radiaproducts.com (PHONE) 800-221-1083 | (INTL) +1-763-533-2969 | (FAX) 763-533-0015
To avoid damage to the pail and machine! Be
sure the wooden disk is properly seated in the
recess under the pail.
(A)
INSTALL A 5 GALLON METAL PAIL:
1.
Raise the top plate enough to allow room
for a 5 gallon pail.
2.
Open the machine door.
3.
Position a wooden disk
(A) 6784971
(for metal
pails only)on the ledge and place the metal pail over
the disk so it fits inside the bottom of the pail.
Place a foam pad
(B) 6784970
at the top of the pail.
See below for proper positioning.
4.
Slide the pail with the foam pad
(B)
and
wooden disk
(A)
onto the lower clamp.
5.
Close the cabinet door and start the
machine.
INSTALL A 5 GALLON PLASTIC PAIL:
Follow steps 1 - 4, but do not use the wooden
disk
(A)
under the pail.
(A)
Type of Pail
Example
Metal Pail—Screw Top
Center the foam pad on top of
the pail. Be sure the cutout
fits near the cap.
Metal Pail—Snap-In Plug
Cover the plug with the foam
cover. Be sure the cutout
faces the center.
Plastic Pail—Screw Top
Center the foam pad on top of
the pail. Be sure the cutout
fits snug around the cap.
Plastic Pail—Snap-In Plug
Cover the plug with the foam
cover. Be sure the cutout
faces the center.
Metal pail screw top
Metal pail snap-in plug
Metal pail screw top
Metal pail snap-in plug
Plastic screw top pail
Plastic snap in plug pail
Plastic screw top pail
Plastic snap in plug pail
(B)
DO NOT
run the machine without a container
in place.
DO NOT
mix more than 80 lb. (36.3 kg).
(B)
4.2 Install a 5 Gallon Pail
..Operation, Continued
Operation, Continued..
