- Page 20 -
5.4
About the Setup Wizard
The Model 8200’s Setup Wizard can complete all the other
configuration settings. It will drive
the antenna through its full range of motion along each axis.
After it runs, all settings remain available to be edited.
Requirements:
•
Working limit switches must be in place on every axis.
Without them, the antenna will drive into
its hard stops and
damages and/or injury may occur.
•
The Model 8200 must be installed and connected properly, including the Setup
screens for Site, Receiver (if any), and Encoders (see above).
•
The antenna must not be tripping any limit switches.
•
Any limit jumpers need to be removed.
•
How long will it take?
Expect the Setup Wizard to take the time needed to exercise
the specific antenna fully, along each axis, and to perform any other tasks as
described. The antenna will be in motion a number of times during this operation.
Even if it pauses, motion may resume until the Setup Wizard concludes.
Also note: If
the Setup Wizard is interrupted for any reason, it will start over when it is run again.
