Installation of Drywall Anchors
Half Moon Pot
Rack
TOGGLER® brand SNAPTOGGLE® Toggle Bolt Installation Instructions. DO NOT attempt
to test the toggle as you will be unable to use them again. Need additional toggles? You
may purchase them at Lowes or find a local store on toggler.com.
IMPORTANT! If your house is older (maybe a Victorian?) with lath
board plaster ceilings and walls, DO NOT use the new drywall an-
chor system. Old lath board plaster walls are not strong enough to
hold drywall anchors. In this case, you must attach the wall rack to
wood studs with wood lag screws (not included with your rack).
See diagram at bottom of page
1)
Using an electric drill, drill a ½” hole at your
UPPER
point. Hold
metal channel flat alongside plastic straps and slide channel
through hole. Minimum clearance behind wall should be 1
⅞
”.
NOTE: If a wood stud happens to be located at one of those
points,
Use a 3/16” x 1 ½” wood screw (provided) and screw it into the
stud. (Pre-drill a 1/8” hole in the stud so the
screws are easier to
screw into the hole).
2)
Firmly push plastic cap up along guide straps with other hand.
Press cap inside the hole, so flange is flush with drywall surface.
3)
Bend straps at wall by pushing side to side, snapping off straps
level with flange of cap..
4)
Install the
LOWER
red sleeve anchors. Using an electric drill
with 3/16” bit, drill a hole at each of the
LOWER
marks. With
your
hammer, gently tap a red wall screw sleeve (30B) into each
hole until it is flush with the drywall surface.
5)
Now position the rack on the wall ~ lining up hole at
TOP
of arm with
UPPER
hole in wall. Screw
button head bolt (19C) through arm and into wall anchor. Tighten bolt snugly.
7
) Align the holes in the back bar over the red plastic sleeves. Insert screw (30A) through each hole
and tighten. Install the grid and brackets.
That’s It! You are now ready to hang your pots & utensils!
Toggler ® Independent Lab Results
(Anchor load before failure per attachment point)
TENSILE
(ceiling)
SHEAR
(wall)
½” drywall 275 lbs.
½” drywall 292 lbs.
5/8” drywall 576 lbs.
5/8” drywall 406 lbs.
