5
Water temperature max.
35° C
3. OPERATION
a. Before use
-
Remove all packing materials. Keep them out of the reach of children. There is a risk of
accidents and suffocations if children play with plastic wrappings and bags.
-
Check that the appliance, power cord, power plug and all accessories have not been damaged
during transport and that the appliance is complete. In case of damage or missing parts, do not
use the pump and take it to your dealer.
b. Installation
If the pump is used in the vicinity of swimming pools, garden ponds, it must be supplied
through a residual current device (RCD) having a rated residual operating current not
exceeding 30 mA (according to VDE 0100, part 702.738). If people are in the pool or in the
garden pond, do not put the pump on.
Contact a qualified electrician for more advice about electrical installation.
Ask a specialist to check the conformity of the grounding and the neutralization. It must
comply with national safety regulations.
The pump must not run dry. The pump, cable and connectors must be protected against
freezing and humidity.
Avoid the discharge of aggressive liquids and the discharge of abrasive materials.
Warning
When installing the pump, attach the pump with its handle (do not use other parts of the appliance
for hanging), or place it in the bottom of the place where it must be installed. In order to ensure
proper operation of the pump, the bottom must always be free of mud or other impurities.
If the water level is too low, any mud deposits may dry and prevent the pump from starting.
Therefore, it is essential to control the submersible motor pump at regular intervals. (Perform
start-up tests.) The float switch is set so that commissioning is immediately possible.
The submersible pump is installed as follows:
-
In a stationary position with fixed pipeline or
-
In a stationary position with a flexible hose pipe.
c. Connection to the network
The submersible motor pump that you have just purchased is equipped with a safety socket. The sink
is designed to be connected to a 230V/50 Hz safety socket.
Make sure the plug is sufficiently protected by fuses (minimum 6 amps) and in perfect condition. Plug
the plug into an outlet; it is ready for commissioning.
If the mains cable or plug is damaged by external elements, it is absolutely forbidden to repair the
cable!
Summary of Contents for RAY400EPDW
Page 9: ...9...