ORIGINAL INSTRUCTIONS
8.3 Forward/reverse switch
▪Push the forward/reverse switch (2) from right to left side to drill holes and fasten screws.
▪Push the forward/reverse switch (2) from left to right side to loosen screws. Always wait until the motor has come to a
complete standstill before changing the direction of rotation.
8.4 Adjusting the torque
This machine has been fitted with an adjustable coupling (18+1 pos.) to limit the torque when tightening screws.
▪Turn the adjustment collar (3) clockwise to reduce the torque and counterclockwise to increase the torque. The correct
setting depends on the type and size of the screw and the work piece.
▪In case of doubt, start with the lowest setting and increase the torque until you have reached the desired result.
▪For drilling, turn the adjustment collar fully counterclockwise (to the drilling symbol).
8.5 Switching on and off
▪Push the forward/reverse switch (2) on the left side or on the right side.
▪To switch on the machine, press the on/off switch (1).
▪To switch off the machine, release the on/off switch.
8.6 Variable speed
▪Applying more pressure to the On/Off switch will increase the speed.
▪Applying less pressure to the On/Off switch will decrease the speed.
8.7 Lower/higher speed selecting
▪Lower speed: switch Speed convert button to position “1”.
▪Higher speed: switch Speed convert button to position “2”.
9. CLEANING AND MAINTENANCE
Attention! Before performing any work on the equipment, pull the power plug.
9.1 Cleaning
Keep the ventilation slots of the machine clean to prevent overheating of the engine.
Regularly clean the machine housing with a soft cloth, preferably after each use.
Keep the ventilation slots free from dust and dirt.
If the dirt does not come off use a soft cloth moistened with soapy water.
Never use solvents such as petrol, alcohol, ammonia water, etc. These solvents may damage the plastic parts.
11
▪Open the chuck by turning the collar.
▪Insert the drill or screw bit in the chuck.
▪Close the chuck by firmly tightening the front collar while holding the rear part of the chuck with the other hand.
▪In order to remove the drill or screw bit proceed in reverse order. Before positioning or removing a drill or screw bit
always remove the battery from the machine.
