Racing RACFBE65T, User Manual

Page: 11 / 19

4. ASSEMBLY
At least two people are required to install the device.
4.1 Fitting the machine foot (fig. 2)
Mount the machine foot (5) using two hexagon screws (b) and washers on the holes provided.
4.2 Fitting the handle (fig. 2)
Mount the handle (4) using two Allen screws (b), two washers and two thin nuts on the holes
provided on the machine foot.
4.3 Fitting the wheels (fig. 3)
Fit the wheels (7) on the axles.
Secure the wheels (7) using the provided locking rings (c).
Fit the wheel caps (d) on the wheels.
4.4 Installing the protective guard (Fig. 4 - 8)
Mount the lower cover (B) to the right side of the machine using four Allen screws (e). (fig. 4)
Mount the lower cover (C) to the left side of the machine using three Allen screws (e) (fig. 4)
Fit the side cover (D) into the lower cover (B) and secure it with five Allen screws (e) and five
hexagon nuts (g). (fig. 5)
Fit the side cover (F) into the lower cover (C) and secure it with three Allen screws (e) and three
hexagon nuts (g). (fig. 5)
Connect the holders of the side flaps (E) with the hinges of the side cover (D) and (F). (fig. 5)
Fit the rear side cover (D) into the lower cover (B) and into the side cover (D) and secure it with
two Allen screws (e) and two hexagon nuts (g). (fig. 6)
Secure the rear side cover (G) with the hexagon screw (f). To do this, you have to move the
control handle (1) away to facilitate access for the hexagon screw (f). (fig. 7)
Connect the holders of the upper flap (H) to the hinge of the upper cover (I)
Clip the cover (I) into the side covers. (fig. 7)
Attach the flaps (J) to the hinge of the side covers (E).
Now clip the flaps (J) together with the flap (H). (fig. 8)
4.5 Fitting the tray table (fig. 9)
Push the tray table (3) into the holder provided.
IMPORTANT! You must fully assemble the appliance before using it for the first time!
5. OPERATION
Before start-up, place the splitter on a stable, level and flat workbench so that the control button
sits at a height of 72 - 85 cm.
Make sure the machine is completely and expertly assembled. Check before every use:

the connection cables for any defective spots (cracks, cuts etc.).

the machine for any possible damage.

the firm seat of all bolts.

the hydraulic system for leakage.

the oil level and

the safety devices
5.1 Checking the oil level (Fig. 10)
The hydraulic unit is a closed system with oil tank, oil pump and control valve. Check the oil level
regularly before every use. Too low an oil level can damage the oil pump. The correct oil level is
approx. 10 to 20 mm below the oil tank surface.
If the oil level is at the lower notch, then the oil level is at a minimum. Should this be the case, oil
11