21
-
Replace the cleaned and adjusted spark plug or replace the damaged
spark plugs (Torch F6RTC or LG F6RTC)
d. Adjust the cable (fig. P)
If the control cable for the transmission is out of sync and has too much
play, you can fix it.
-
Loosen the small lock nut (32a).
-
Turn the adjusting nut (32b) counter clockwise: The control cable is
shortened.
-
Turn the adjusting nut (32b) in a clockwise direction: The cable is
extended.
e. Sharpen/change the blades
-
Remove the spark plug from its socket and inspect the blade for
wear or damage.
-
Always make a blunt blade sharpened by a specialized garage as it
can perform an unbalance check.
-
Always sharpen a blade or replace an unbalanced blade with a
specialist. Incorrect mounting may cause serious. The replacement
of the blade shall not be done by the operator.
Instructions for sharpening and changing the blade
WARNING: Wear gloves, turn off the engine and remove the spark
plug before proceeding.
The blade is made of hardened steel. To get a clean job, sharpen the
blade frequently, about every 25 hours of use. Make sure the blade
is always well balanced.
Insert a small iron pin (2 or 3 mm in diameter) into the hole in the
middle of the blade: it must remain horizontal. If the blade does not
stay horizontal, balance it by sharpening it further on the side
where it is leaning.
