17
g. Adjust the cutting height (Figure
and
)
The device has 6 positions for adjusting the cutting height (from 25 to 75
mm):
-
Pull the lever (18) outward and push it to the desired position.
-
Press the lever inward again.
-
Set the corresponding height also on the front wheel. The
label on the wheel mounting shows which height of the
machine is set. Loosen the wing nut and secure the wheel
to the desired position.
-
Tightening the clamp locks the wheel in position. If the wheel rotates
in the opposite direction, lift the clamp to remove the immobilizer.
Bring the wheel to its new position and re-engage the clamp.
4. OIL AND FUEL FILLING
a. Oil filling
-
Unscrew the oil tank cap with dipstick and pour oil into the tank. The
oil tank has a capacity of 600 ml. Use a brand name oil (SAE 30 for
example).
-
To check the oil level, wipe the dipstick with a clean cloth
and put it back into the tank.
-
Read the oil level on the dipstick after pulling it out. The oil
level must be between the two minimum and maximum
marks.
-
Wipe off any drops of oil you have dropped and close the
oil tank cap
-
Check the oil level each time before mowing and readjust when it is
below the bottom mark.
b. Fill the fuel tank
Caution! Gasoline is flammable and toxic:
-
keep the gasoline in suitable containers;
-
refuel only in the open air and never when the engine is running or
the machine is hot;
-
open the tank cap carefully so that no overpressure can develop;
