910500
– 4-Cycle Gas Power
Impact Wrench
Impact
Phone: (262) 637-9681
Email:
5.2022 Rev 1
Page
8
of
27
Inspect safety decals and replace when they become unreadable or are damaged.
Always
comply with all instructions provided on any decals or placards installed on the machine and with
any relevant amplifying information provided in this manual or other general operating procedures.
Always
keep the machine clean and free of debris. Operate the machine in a safe and responsible
manner. Exercise caution when fueling, working on or near rotating or moving components, hot
components, and fuel systems. Be aware of potential fire hazards and prevent sparks, exhaust, etc., from
starting fires on the machine and/or work area.
Always
shut off the engine. Make sure that all controls are in a safe position and install all appropriate
locking and safety devices before doing any of the following:
•
Lubricating
•
Adjusting
•
Installing Tooling
•
Making Repairs
•
Performing Service
Do not
grab or hold the unit with the rotating anvil.
Hold the handles firmly with both hands and make sure to stand on a firm base or ground.
Do not
touch the spark plug or the high voltage cord during operation as it may cause electric shock.
To avoid burn do not touch places like the engine, muffler, or exhaust when it will get very hot during use
and eve after the engine stops. It takes time to cool down.
If the fuel is leaking during operation, stop the engine immediately, and repair. It may cause a fire.
When operating for a long period of time, take a break from time to time to avoid possible white finger
disease which is caused by vibration.
Antivibration systems do not guarantee that you will not sustain white
finger disease or carpal tunnel syndrome.
Therefore, continual, and regular users should monitor closely the condition of
their hands and fingers. If any of the above symptoms appear, seek medical
advice immediately.
Tool Safety
Always
comply with all Lock Out / Tag Out Procedures and other safety procedures established for the
local
work environment.
Do not
make any modifications without authorization or written approval from Racine Railroad Products.
Replace all Racine Railroad Products and OEM parts with genuine Racine Railroad Products and OEM
parts. Using non-OEM parts may compromise the safety of the machine.
Always
make sure that all guards, covers, belts, and operating components are in good working order
and that all controls are in the appropriate position before starting the engine.
Always
inspect the entire tool before each use. Replace damage parts. Check for fuel leaks and make
sure all fasteners are in place and securely fastened.
Replace parts that are cracked, chipped, or damaged in any way before using the tool.
Use only accessories recommended by Racine Railroad Products for this tool.
Use only genuine replacement parts as recommended by the manufacturer.
