Raceface WH141427.5, Installation Sheet

Page: 4 / 9

17mm
HEX 12 mm
6 7
HuB END CApS
• This wheelset comes with hub end caps to change the hub to different axle widths and diameters.
• to change the hub end caps on the front wheel simply pull off the end caps on the front hub and
press on the desired end caps.
• To change out the Rear hub end caps follow this process – pull off non-drive side end cap, then
insert 12mm hex wrench into non-drive side (image). Take 17mm cone wrench and engage it on
the flat edges of the drive side end caps– while holding the 12mm hex wrench steadily turn that
drive side end cap clockwise to loosen. Once loosened the drive side cap will slide off, then the
new caps can be installed in a reverse order of how the original caps were removed.
MAINTENANCE
• Do not use pressurized water for cleaning Race Face wheels. use mild soap and water
with a sponge or wash cloth to clean the wheels.
• Do not install/remove the tire or rim strip with a screwdriver or any other metal tools not
designated for tire or rim strip installation.
• Do not attempt to service the freehub body or modify the wheels from the original usage
rating or specs.
• When transporting wheels do not set objects on wheels.
maintenance Interval (Hours)
□
Check that wheel is properly seated and centered with
the axle fully secured
□
Check tire pressure and tread condition
□
Check rims and spokes for damage
□
Check that wheels spin freely
Every ride
□
Clean and grease axle mechanism 100
□
Perform front and rear hub maintenance 100
□
Replace tubeless rim tape (if applicable) 100
WArrAntY
This Race Face wheelset comes with a warranty period of 2 years from date of purchase. This
warranty covers the product from manufacturing defects. This warranty coverage is for the original
owner only and proof of purchase is required. For more details on Race Face warranty coverage refer
to www.raceface.com
EnGLIsH