![background image](http://html1.mh-extra.com/html/racal-instruments/1260/1260_user-manual_3122956024.webp)
User Manual 1260-35
Module Specific Syntax 3-2
Example:
OPEN 3.02
This open command will open channel 2 on the module at switch
card address 3
CLOSE Command
The Module Specific Syntax for the CLOSE command is the same
as for the OPEN command.
PSETUP
Command
The PSETUP command causes the specified module setup to be
transmitted to the VXI Controller. The syntax used is:
PSETUP <module address>[;<module address>] [;<module
address>] where <module address> is the address.
The responses to the PSETUP command for the 1260-35
Multiplexer/Scanner is as follows:
1260-35:
Two-wire
<module address>. 1260-35B, Two-wire Scanner/Multiplexer
Module
<module address>. BBM
<module address>.END
1260-35:
Four-wire
<module address>. 1260-35A, Four-wire Scanner/Multiplexer
Module
<module address>. BBM
<module address>.END
The response to the PSETUP command consists of a header on
the first line. The header describes the model number followed by
an A or B designating four or two-wire, respectively. The next line
designates the setup mode for scanning which, by default, is
Break-Before-Make (BBM). The last line containing the "END"
characters denotes no more information to report.
PDATAOUT
The PDATAOUT command causes the specified module to
transmit the CLOSED state of the relays within the switching
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com