User Manual 1260-38
Module Operation 3-6
<module address>.END
The response to the PDATAOUT command consists of a header
on the first line as with the PSETUP response. The next line
details the channels currently closed on the module and is blank
when no channels are closed. Again, the last line is denoted by the
11
END'
1
string of characters.
PSETUP Command
The PSETUP command causes the specified module setup to be
transmitted to the VXI Controller. The syntax used is:
PS[ETUP] <module address>[ ;<module address>] [;<module address>]
Where:
<module address> is the switch card address.
The responses to the PSETUP command for the 1260-38
Multiplexer/Scanner is as follows:
1260-38:
Two-wire
<module address>. 1260-38A 1x128 2-WIRE SCANNER/MULTIPLEXER
<module address> . BBM
<module address>.END
1260-38
Four-Wire
<module address>. 1260-38B 1x64 4-WIRE SCANNER/MULTIPLEXER
<module address>. BBM
<module address>.END
The response to the PSETUP command consists of a header on
the first line. The header describes the model number following an
A or B designating two or four-wire, respectively. The next line
designates the setup mode for scanning which, by default, is
Break-Before-Make (BBM). The last line containing the "END"
characters denotes no more information to report.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
