12
3)
OBD
II cable
-- Provides power to tool and communicates
between tool and the vehicle
4)
USB Cable
-- Used to upgrade the scan tool
5)
Carry Case
-- A nylon case to store the scan tool when not in use
3.4 Navigation Characters
Characters used to help navigate the scan tool are:
1)
“
►
”
-- Indicates current selection.
2)
“
↓
”
-- A flashing Down Arrow indicates additional information is
available on the next screen.
3)
“
↑
”
-- A flashing UP Arrow indicates additional information is
available on the previous screen.
4)
“Pd” --
Identifying a Pending DTC when viewing DTCs.
3.5 Keyboard
No solvents such as alcohol are allowed to clean the keypad or
display. Use a mild nonabrasive detergent and a soft cotton cloth.
Do not soak the keypad as the keypad is NOT waterproof.
3.6 Power
A. Internal Battery Power
The scan tool has a 9V cell battery that provides power for tool
upgrading and off-car reviewing and analysis. Press the power key
to turn on the scan tool. And the voltage of the batteries is checked
each time the scan tool is powered up. If the voltage is low, a
message “Battery is low!” shows on the screen. Replace the battery
as per instructions in “Battery Replacement” on paragraph 3.8.
If the scan tool is stored for a long period of time, remove
batteries to prevent battery leakage from damaging battery
compartment.
B. Vehicle Power
The external power of the scan tool is provided via the vehicle Data
Link Connector (DLC). Just follow the steps below to turn on the
scan tool:
1) Connect the OBD II Cable to scan tool.
