RabbitCore RCM3305, User Manual

Page: 40 / 160

34 RabbitCore RCM3305/RCM3315
A program “runs” in either mode, but can only be downloaded and debugged when the
RCM3305/RCM3315 is in the Program Mode.
Refer to the
Rabbit 3000 Microprocessor User’s Manual
for more information on the pro-
gramming port.
4.3.2 Standalone Operation of the RCM3305/RCM3315
The RCM3305/RCM3315 must be programmed via the Prototyping Board or via a similar
arrangement on a customer-supplied board. Once the RCM3305/RCM3315 has been pro-
grammed successfully, remove the programming cable from the programming connector
and reset the RCM3305/RCM3315. The RCM3305/RCM3315 may be reset by cycling the
power off/on or by pressing the
RESET
button on the Prototyping Board. The RCM3305/
RCM3315 module may now be removed from the Prototyping Board for end-use
installation.
CAUTION: Disconnect power to the Prototyping Board or other boards when removing
or installing your RCM3305/RCM3315 module to protect against inadvertent shorts
across the pins or damage to the RCM3305/RCM3315 if the pins are not plugged in
correctly. Do not reapply power until you have verified that the RCM3305/RCM3315
module is plugged in correctly.