Distributor of Digi International: Excellent Integrated System Limited
Datasheet of 20-101-0455 - COMPUTER SGL-BOARD ETH BL2010
Contact us: [email protected] Website: www.integrated-circuit.com
User’s Manual
53
5. U
SING
THE
TCP/IP F
EATURES
Chapter 5 provides an introduction to using the TCP/IP features
on your BL2000 board.
5.1 TCP/IP Connections
Before proceeding you will need to have the following items.
•
If you don’t have Ethernet access, you will need at least a 10Base-T Ethernet card
(available from your favorite computer supplier) installed in a PC.
•
Two RJ-45 straight through Ethernet cables and a hub, or an RJ-45 crossover Ethernet
cable.
The Ethernet cables and Ethernet hub are available from Rabbit in a TCP/IP tool kit. More
information is available at
www.rabbit.com
.
1. Connect the AC adapter and the programming cable as shown in Chapter 2, “Getting
Started.”
2. Ethernet Connections
If you do not have access to an Ethernet network, use a crossover Ethernet cable to con-
nect the BL2000 to a PC that at least has a 10Base-T Ethernet card.
If you have Ethernet access, use a straight through Ethernet cable to establish an Ethernet
connection to the BL2000 from an Ethernet hub. These connections are shown in Figure 21.
Figure 21. Ethernet Connections
BL2000
User’s PC
Ethernet
crossover
cable
Direct Connection
(Network of 2 computers)
BL2000
Hub
Ethernet
cables
To additional
network
elements
Direct Connection Using a Hub
Board
Board
58 / 95
58 / 95
