Rabbit RabbitCore RCM5400W, User Manual, Page: 49 / 120

OEM User’s Manual 43
A program “runs” in either mode, but can only be downloaded and debugged when the
RCM5400W is in the Program Mode.
Refer to the
Rabbit 5000 Microprocessor User’s Manual
for more information on the pro-
gramming port.
4.4.2 Standalone Operation of the RCM5400W
Once the RCM5400W has been programmed successfully, remove the programming cable
from the programming connector and reset the RCM5400W. The RCM5400W may be
reset by cycling the power off/on or by pressing the
RESET
button on the Prototyping
Board. The RCM5400W module may now be removed from the Prototyping Board for
end-use installation.
CAUTION: Power to the Prototyping Board or other boards should be disconnected
when removing or installing your RCM5400W module to protect against inadvertent
shorts across the pins or damage to the RCM5400W if the pins are not plugged in cor-
rectly. Do not reapply power until you have verified that the RCM5400W module is
plugged in correctly.