background image

INSTRUCTIONS

SWISH® FA INSTALLATION

RAB Lighting is committed to creating high-quality, aff ordable, well-designed and energy-effi  cient LED lighting and controls that make it easy for electricians to install

and end users to save energy. We’d love to hear your comments. Please call the Marketing Department at 888-RAB-1000 or email: [email protected]

Fig: 1

Fig: 2

Fig: 3

IMPORTANT

READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.

RAB fi xtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper grounding is 
required for safety. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON 
FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED. 

WARNING: Make certain power is OFF before installing or maintaining fi xture. No user serviceable parts inside. 
CAUTION: For proper weatherproof function all gaskets must be seated properly and all screws inserted and tightened 
fi rmly. Apply weatherproof silicone sealant around the edge of the ceiling mounting box and/or junction box. This is 
especially important with an uneven ceiling surface. Silicone all plugs and unused conduit entries.

RECESSED CEILING MOUNTING

The fi xture is suitable only for INDOOR RECESSED CEILING 
application. Above ceiling access required.

To mount in an insulated or non-insulated ceiling - 

9/16” or 15/16” 

exposed Flat Tee Grid Ceiling follow the steps below. 
1. 

Rotate and slide the

 Housing 

as required to fi t through the 

Tee-Grid Bar

and place it as indicated by the directional arrow 

as shown in Fig. 1.

2.  Firmly bend the pre-installed

 Grid Clips 

(4)

against the

Tee-Grid Bar 

to secure the

 Housing 

as shown in Fig. 2

3.  Support wires are required by Installation Codes. Support the

Housing

 to the building structure by 

Support Wires

(supplied by 

others)

through the

 Support Wire Hole

as shown in Fig. 3.

4. 

Make sure that the orientation of the

 Access Plate 

faces an 

accessible tile to make electrical splices.

5.  Loosen screw on

 Access Plate 

and remove the

 Access Plate 

(Fig. 1)

. Knock out appropriate

Conduit Knockouts 

on the

Access Plate 

to route input conduit. Use appropriate conduit 

connectors as required by code.

6.  Connect wires as shown in wiring diagram 

(Fig 4).

 Push all 

wires back into the

 Splice Box. 

Be careful not to pinch wires. 

WARNING: To prevent wiring damage or abrasion, do not 

expose wiring to edges of sheet metal or other 

sharp objects.  

7. 

Replace

 Access Plate 

and tighten

 Access Plate Screw.

8.  After installation remove protective fi lm from the outer surface 

of the lens.

SWISHFA -2X2

SWISHFA -2X4

Tee-Grid 

Bar

Access Plate

Screw

Housing

Grid Clip

Support Wire 

(supplied by others)

Conduit Knockouts

Firmly bend Grid 

Clips against the 

Tee-Grid Bar

Tee-Grid Bar

Housing

nominal 4”

Support Wire Hole

Support Wire             

(supplied by others)

Tee-Grid Bar

Access Plate

Grid Clips 

(4)

Reviews: