INSTRUCTIONS
SWISH® FA INSTALLATION
RAB Lighting is committed to creating high-quality, aff ordable, well-designed and energy-effi cient LED lighting and controls that make it easy for electricians to install
and end users to save energy. We’d love to hear your comments. Please call the Marketing Department at 888-RAB-1000 or email: [email protected]
0-10V DIMMABLE WIRING
FIELD ADJUSTMENT
CLEANING & MAINTENANCE
TROUBLESHOOTING
Universal voltage driver permits operation at 120V through 277V,
50 or 60 Hz. 0-10V control wires must be rated for 300V minimum.
For 0-10V dimming follow the wiring directions shown below
(Fig. 4)
.
1. Connect the black fi xture lead to the
LINE
supply lead.
2. Connect the white fi xture lead to the
COMMON
supply lead.
3. Connect the
GROUND
wire from fi xture to supply ground.
Do NOT connect the
GROUND
of the dimming fi xture to the
output.
4.
Connect the purple fi xture lead to the (V+) DIM lead.
5. Connect the pink fi xture lead to the (V-) DIM lead.
Follow instructions below to change the fi xture wattage and/or
color temperature from the factory settings.
Factory Settings: 2X2 - 29W, 4000K, 2X4 - 39W, 4000K
1.
Locate the
Selector Switches
on the side of the driver as shown
in Fig 5.
2. Select a color temperature
(CCT)
and/or power
(W)
by sliding
the respective switch to the desired value
(Fig 6)
.
Fig. 5
Fig. 4
Fig. 6
CAUTION: Be sure fi xture temperature is cool enough to touch.
Do not clean or maintain while fi xture is energized.
1. Clean polycarbonate lens & fi xture with non-abrasive cleaning
solution.
2. Do not open fi xture to clean the LEDs. Do not touch the LEDs.
1. Check that the line voltage at the fi xture is correct. Refer to
wiring directions.
2. Is the fi xture grounded properly?
PINK
LIGHT
FIXTURE
Vaux 12V
YELLOW
GROUND
GROUND
( - ) DIM V
( + ) DIM V
COMMON
LINE
BLACK
WHITE
PURPLE
Selector Switches
Color Temperature
(CCT)
Selection Switch
Power
(W)
Selection Switch
2X2
2X4
