INSTRUCTIONS
STL110H/L, STL110HB/L, STL110R/L INSTALLATION
RAB Lighting is committed to creating high-quality, affordable, well-designed and energy-efficient LED lighting and controls that make it easy for electricians to install
and end users to save energy. We’d love to hear your comments. Please call the Marketing Department at 888-RAB-1000 or email: [email protected]
WIRING
Fig. 5
Fig. 6
WIRING
Bar
Hook
Screws
CU4 EZ
Plate
Universal
Mounting Bar
Gasket
Center
Screw
Insert
close-up
plugs in
unused
holes
Finishing
Cap
O-Ring Gasket
Black
Black
Red
Red
(pigtail)
Ground
Ground
Power In
White
White
Note:
These instructions do not cover all details or variations in equipment nor do they provide for every possible situation during installation, operation or maintenance.
Red pigtail is only used to switch remote or additional fixtures.
1. Attach the
Universal Mounting Bar
with the
Bar Screws
(provided) to the junction box as shown in
Fig 5
. If you are
attaching your STL110 kit to a surface mount weatherproof box,
you must use the metal plate with the attached gasket.
The gasket faces the Junction Box.
2. Easy Wiring Tip: Use the “S” shaped
Hands Free Hanging Hook
to hold the
EZ Plate
during wiring.
3. Bring power leads and sensor kit leads through holes in all
gaskets into junction box.
4. Strip 1/2” of insulation from all leads.
5. Attach ground wire(s) to junction box grounding screw.
Connect as shown in
Fig 6
.
6. Twist on wire nuts. Secure with electrical tape.
7. Align
EZ Plate
and metal mounting plate to insure proper seal.
Tighten
EZ Plate
center screw (make sure
O-Ring Gasket
is
on the screw) to attach
EZ Plate
to the box. There are 2 screws
supplied. Use the one which suits your assembly best.
8. Insert plastic
Finishing Cap
in the center of the
EZ Plate
for a
weatherproof seal.
9. Use silicone sealant around all openings to insure a
weatherproof seal.
10. Screw in lamps (if not already installed). Turn on power.
Conduct walk test to adjust sensor response.
Fig. 7
SWITCHPLATE LABEL
STL110
Switchplate label with self-adhesive backing
(Fig 7)
.
Attach Stealth operating instruction label to switchplate for quick
and easy reference.
