INSTRUCTIONS
HALV Indoor Architectural-Grade LED Wall Sconce
RAB Lighting is committed to creating high-quality, affordable, well-designed and energy-efficient LED lighting and controls that make it easy for electricians to install
and end users to save energy. We’d love to hear your comments. Please call the Marketing Department at 888-RAB-1000 or email: [email protected]
IMPORTANT
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.
RAB fixtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper grounding is
required for safety. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON
FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
WARNINGS:
• Make certain power is OFF before installing or maintaining fixture. No user serviceable parts inside.
• To prevent wiring damage or abrasion, do not expose wiring to edges of sharp objects.
CAUTION:
• This fixture supports the following protocols – Triac and ELV at 120V ONLY. For 0-10V dimming, connect purple wire to the
V+ DIM lead and the grey wire to the V-DIM lead. This fixture is damp listed and suitable for indoor applications on walls.
Driver is 120V – 277V and 50Hz or 60 Hz
.
HALV
Mounting the fixture on a standard 4 x 4 J-BOX
.
This fixture is damp listed and suitable for indoor applications
on walls
1. Loosen the (4)
driver/LED mounting
phillips head screws and
separate the
driver/LED assembly
from the wall plate. No need
to remove the screws completely, use the keyhole.
DO NOT
TOUCH THE LEDs
. See
Figure 1
.
2. Set
Driver/LED
assembly aside.
3. Pull wires from j-box through the
Wall Plate
opening and
mount Wall Plate to junction box using screws provided with the
junction box. Making sure the
‘S’ hook
notch is at the top.
4. Hang the
Driver/LED Assembly
on the
‘S’ hook
as shown in
Figure 1a
.
5. Make wiring connections. Push wire nuts through hole into
J box.
6. Replace
Driver/LED Assembly
making sure not to pinch any
wires.
7. Tighten Driver/LED mounting screws.
J-BOX WALL MOUNTING
(standard models)
‘S’ Hook Notch
Wall Plate
Driver/LED
Assembly
DO NOT TOUCH LEDs
Driver/LED
Screw Keyhole
Wire Hole
Driver/LED mounting screws
‘S’ Hook
FIG.1
‘S’ Hook
‘S’ Hook
FIG.1a
Summary of Contents for HALV
Page 5: ......
