7
5. Attach ground wire(s) to junction
box grounding screw. Connect as
shown in wiring diagram on right
6. Twist on wire nuts. Secure with electrical tape.
7. Align gaskets, EZ Plate and metal
mounting plate to insure proper seal.
Tighten EZ Plate center screw (make
sure O-ring gasket is on the screw) to
attach EZ Plate to the box.
8. Insert plastic Finishing Cap in the
center of the CU4 EZ Plate for a
weatherproof seal.
9. Use silicone sealant around all openings to insure a weatherproof seal.
10. Insert bi-pin, T4 halogen lamp into Bullet Flood fixture (see darwing below).
Turn on power. Conduct walk test to adjust sensor responses.
Power Quality
Sensors should not be installed on a circuit that also feeds motor loads such
as HVAC equipment, kitchen appliances, or garage door openers.
If voltage varies significantly from 120 volts, sensors may malfunction.
QB Flood with
Integra Hood Glare shield
removed for lamping
Use protective cushion to hold lamp when inserting -
DO NOT touch lamp with fingers