FXLED INSTALLATION INSTRUCTIONS
Thank you for buying RAB lighting fixtures. Our goal is to design the best quality products to get the job done right. We’d like to hear your comments.
Call the Marketing Department at 888-RAB-1000 or email: [email protected]
®
IMPORTANT
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE
.
RAB fixtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper grounding
is required for safety. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A
PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
WARNING: Make certain power is OFF before installing or maintaining fixture. No user serviceable parts inside.
SLIPFITTER MOUNTING
1. The slipfitter mounting fits a 2 3/8” O.D.
Tenon
. Place the
slipfitter over the
Tenon
and secure the fixture with the
Set Screws
(2) on the side of the slipfitter.
2. Remove two screws on side of
Round Cover Plate
.
Remove the
Round Cover Plate
and adjust the angle of
the fixture.
3. Loosen the
Locking Bolt
and swivel fixture to desired
angle.
4. Tighten the
Locking Bolt
and re-attach
Round Cover
Plate.
Tenon
Set Screws
Round
Cover
Plate
Locking Bolt
Pivot Bolts
TRUNNION MOUNTING
CAUTION
: UL and C-UL listed or CSA certified liquid tight
cord grip suitable for use with three conductor type STW
flexible cord shall be used for connection to a wet location
outlet box provided by others.
To adjust the angle of the fixture using the trunnion:
1. Loosen the
Pivot Bolts
& angle locking screw.
2. Adjust fixture to desired angle.
3. Tighten
Pivot Bolts
& angle locking screw.
TROUBLESHOOTING
1. Check that the line voltage at the fixture is correct. Refer
to wiring directions.
2. Be sure the fixture is grounded properly.
3. Is the photocell, if used, functioning properly?
CLEANING & MAINTENANCE
CAUTION: Be sure fixture temperature is cool enough
to touch. Do not clean or maintain while fixture is
energized.
1.
Clean glass lens with non-abrasive glass cleaning
solution.
2.
Do not open the fixture to clean the LED. Do not touch
the LED.
ACCESSORIES
Chrome Wire Guard:
GDFXLED78W
Poly Shield:
GDFXLED78P
Lens & Door Replacement:
LFXLED78 (bronze)
LFXLED78W
(white)
