WP4 INSTALLATION INSTRUCTIONS
TROUBLESHOOTING
1. Is the proper lamp is installed? Check the wattage
and ANSI code on the fixture label against markings
on the lamp. Refer to Replacement Lamp table above
for verification.
2. Make sure the lamp is not defective. Try a lamp
known to be in operating condition.
3. Check that the line voltage at fixture is correct.
Refer to wiring directions.
4. Is there voltage at the lamp socket? If there is
no voltage, check all connections
5. Is the fixture grounded properly?
6. Is the photocell functioning properly (if used)?
ACCESSORIES AND
REPLACEMENT PARTS
Chrome Wire Guard:
GDWP3W
Door Frame & Glass:
GLWP3F (bronze)
GLWP3FW (white)
Factory Installed Photocell:
“/PC” (120V)
“/PC2” (277V)
“/PCS” (Swivel 120V)
Quartz Restrike
:
“/QR” HID only
Note: These instructions do not cover all details or variations
in equipment nor do they provide for every possible situation
during installation, operation or maintenance.
WP4-IN-0811
REPLACEMENT LAMPS AND
BALLASTS
Lamp
ANSI Ballast
Wattage
Catalog#
Code
Catalog#
High Pressure Sodium
400
LHPS400
S51
BHPSH400QT
Metal Halide
320 Pulse St LMH320PSQ M132
BMHH320PSQ
350 Pulse St LMH350PSQ M131
BMHH350PSQ
400 Pulse St LMH400PSQ M135
BMHH400PSQ
RAB fixture designs are protected under U.S. and International
Intellectual Property laws. Patent Pending.
LIGHT
FIXTURE
(+)LINE
BLACK
(-)COMMON WHITE
GROUND
GROUND
CLEANING & MAINTENANCE
CAUTION: Be sure fixture temperature is cool
enough to touch. Do not clean or maintain while
fixture is energized.
1. Clean glass lens with non-abrasive glass cleaning
solution.
2. As lamps age, light output diminishes. Mass
relamping at regular intervals ensures full light output
at the highest efficiency.
LAMP INSTALLATION
CAUTION: Prior to installing, check that the lamp is
the correct ANSI type and wattage. Observe lamp
manufacturer’s recommendations on lamp operation,
ballast type and burning positions.
1. Disconnect power. Make sure fixture and lamp are
cool enough to touch.
2. Loosen
Door Screws (2)
from the door frame. A
small rubber O-ring will retain screws. Open door.
3. Fully insert lamp into socket.
4. Before closing door, make sure gasket is properly
seated all around the backbox of the wallpack. Close
the door. Tighten
Door Screws
.
Door
Screws
WIRING SCHEMATIC
