Please check contents before assembly.
If any items are missing or damaged,
do not take the unit back to
the store.
Call 1-800-427-5136 for customer service and we will save you time by correcting any problems
directly for you.
CF26 SINGLE CHAIR LOG PORCH SWING
PORCH SWING COMPONENTS
2 - Swing
Bars - 45”
2 - 21”
Seat Ends
2 Arms 24” Long
2 Arm Supports
12” Long
NOTE:
Cracks or Checks in logs are part of the natural
beauty of cedar logs and should not be considered defects.
Preassembled Swing
Seat
Rubber
Mallet
Block of Wood
& hammer
7/16”
wrench
7/16
Socket
# 2
Phillips
Screwdriver
TOOLS REQUIRED
Tape Measure
Regular
Screwdriver
Pencil
or Marker
or
or
or
PORCH SWING HARDWARE
(Shown smaller than actual size)
Two S Hooks
Two 3/8”Washers
Two Barrel
Nuts
Ten Screws
Two 3/8” x 5”
Eye Bolts
*Four 1/4” x 5” Hex
Washer Head
Screws
Hex Washer Head Screws may require:
9/16” wrench
7/16” wrench
3/8” wrench
* Lag screws and washers may be substi-
tuted for Hex Washer Head Screws.
To start hex washer head screws, hammer into wood about
1/2”, then use wrench to tighten.
Do not completely tighten any screws until the unit is fully
assembled and setting on a level surface.
Use a rubber mallet (or block of wood between the hammer
and the unit) to drive doweled ends into holes as far as possi-
ble.
A battery or power screw gun will make assembly easier
and quicker.
NOTE
Install seat ends
onto seat. Align holes in
seat end with dowels on
seat as shown in picture at
right. Repeat on other side.
Secure with screws perpen-
dicular to dowel. IMPOR-
TANT: The single hold
should be place toward the
front of the seat.
STEP 1
front
Please Note:
After you have
installed the seat ends onto the
seat, secure with (4) 2 1/2”
screws. See figures at left.
or
Read all instructions before starting.
