RAB Lighting WP1FC, Installation Instructions

Page: 2 / 2

WP1FC Full Cut-off INSTALLATION INSTRUCTIONS
PHOTOCELL INSTALLATION
A PHOTOCELL MAY BE INSTALLED IN THE FIELD.
1. Remove door and reflector
2. Remove close up plug on top of fixture
3. Install photocell and wire as per diagram
RE-LAMPING
CAUTION:
Prior to installing, check that the lamp is of proper type and wattage. Observe lamp manufacturer’s
recommendations on lamp operation, burning position and ballast type.
1. Disconnect power
2. Make sure fixture and lamp are cool enough to touch
3. Loosen two screws holding door frame
4. Open by swinging door to the left, letting hinge hold door
5. Replace lamp
6. Close door and tighten screws
REPLACEMENT LAMPS
METAL HALIDE ANSI HIGH PRESSURE SODIUM ANSI FLUORESCENT
Wattage Catalog# Code Wattage Catalog# Code Wattage Catalog#
50PS LMH50 M110 35 LHPS35 S76 42 LCFL42
70PS LMH70 M98 50 LHPS50 S68
100PS LMH100 M90 70 LHPS70 S62
100 LHPS100 S54
150 LHPS150 S55
CLEANING
Caution:
Be sure fixture temperature is cool enough to touch. Be sure power is off.
Clean reflector and refractor with a cloth moistened with non abrasive glass cleaning solution.
TROUBLESHOOTING CHECKLIST
Check that:
1. Proper lamp is installed. Lamp is not faulty
2. Line voltage at the fixture is correct
3. Fixture is wired correctly
4. Fixture is grounded correctly
THESE INSTRUCTIONS DO NOT COVER ALL DETAILS OR VARIATIONS IN EQUIPMENT, NOR DO THEY PROVIDE FOR EVERY
POSSIBLE CONTINGENCY TO BE MET IN CONNECTION WITH INSTALLATION, OPERATION OR MAINTENANCE.
EASY INSTALLATION & PRODUCT HELP
©
RAB
Lighting, Inc.
170 Ludlow Avenue Northvale, NJ 07647 USA
1/06
RAB
MAKES
IT
EASY!
Info on Demand
������������������
������������
rabweb.com
�����������������
����������������
Tech Help Line
����������������
������������
Toll Free Fax
�����������������
������������
E-mail
�����������������
����������������
“COM”
PHOTOCELL
WP2FC
WP1FC