Location Considerations:
• Choose a location from which the sensor
can “see” all the paths of movement that
will be illuminated by its lights.
• SmartBox may be painted to blend in
with walls. Carefully apply masking tape
to the sensor lens or use the Lens Mask
Kit provided before painting.
• Sensor functions best when the direction
of expected movement is across its
detection pattern, not towards the
sensor.
• If wall mounting, locate 5-8’ high for
optimum range. Lower mounting height
will reduce range.
Test Period:
The sensor has a 3-minute Test Period
which allows it to be aimed and walk
tested day or night.
• For the first 30 seconds, the lights will be
turned on. During this time, test that all
fixtures and lamps function properly.
• For the next 3 minutes, the sensor will
keep lights on for 5 seconds each time
it detects movement in its Detection
Zone. The sensor will change to
Automatic Mode after the 3 minute Test
Period.
• If another 3 minute Test Period is desired,
turn the power off for at least 10
seconds and back on again.
Walk Test:
The purpose of the Walk Test is to check
and adjust the coverage pattern.
1. Aim the sensor approximately to cover
the area you desire.
2. Start outside the Detection Zone and
walk across the zone until the lights
go on. As distance from the sensor
increases, it will take more movement
to be detected. For instance, at 10 feet, a
half step will be enough, while at 30 feet,
several steps will be necessary.
Picking A Location
Detection Pattern:
• The sensor has a “Double Look Down”
Lens with one “Look Out” zone and
two “Look Down” zones, for excellent
detection both at long and close range
• Detection extends out a maximum of 40
feet and is 180º wide.
• To reduce the Detection Pattern length,
adjust the tilt set screw underneath the
sensor using the hex wrench provided.
• To reduce Detection Pattern width, mask
the sides of the lens with the Lens Mask
Kit provided or opaque weatherproof
tape.
• If sensor is mounted by a doorway at the
top of stairs, be aware that the elevated
mounting height may extend the
sensors range.
Aiming and Walk Testing
S
T
8’
Side View
30’
Double Look Down Lens
60’
30’
Photocell
Turn to moon
symbol for night
only
Turn to sun
symbol for 24
hour operation
(lights turn on
night and day)
3. To reduce range, use the lens masks
provided or tilt sensor down.Repeat
steps #2 and #3 until you are satisfied
with the coverage.
4. The Time Control is factory set between
5-8 minutes. This period starts after
the movement in the Detection Zone
ceases. If less time is desired, turn the
time control counterclockwise. For
more time, turn the control clockwise.
5. The sensor is factory set for night only
operation. To obtain full operation
24 hours per day, turn the Photocell
Control fully clockwise to the sun
symbol. Intermediate settings will allow
the sensor to operate earlier or later at
dusk.
6. Your sensor is ready for operation. See
the Technical Tips pages if additional
help is needed.
Control Panel:
Turn controls gently using the adjustment
tool provided. Do not force past stops.
Top View
9
8
Start
Finish
