How are the Time, Sensitivity and
Test mode adjusted?
Time Control:
Sets the time that
lights will remain on after the
Detection Zone is vacated.
Time setting ranges from
approximately 5 seconds to 15
minutes. Turn gently. Do not
turn past stops.
Test Mode:
Turn time knob to Test
setting. Complete walk test and
set time to desired time setting
(5 sec to 15 mins)
Sensitivity:
Increases or decreases
the responsiveness and range of
the sensor.
CONTENTS:
2
How Does Gotcha Work?
How long do the lights stay on?
Lights remain on as long as there
is movement within the Detection
Zone. Once the zone is vacated,
lights will remain on approximately
5 sec up to 15 minutes, depending
on the time control adjustment.
During initial 60 sec warm-up time,
lights remain on.
Will the sensor detect animals?
Gotcha may detect large animals.
You can limit animal detection by
turning down sensitivity knob or by
placing opaque weatherproof tape
on the lower part of the lens.
How to Manual Override Gotcha?
To Keep lights on at night, flip the
wall switch two times
(OFF-ON-OFF-
ON)
within 5 seconds. Sensor resets
to auto mode after 6 hours. Switch
the power ON and OFF once
(OFF-
ON)
quickly to go to AUTO mode. No
extra wiring needed.
Masking
the lens
The Gotcha infrared sensor “sees” small temperature changes caused by
the motion of people or cars within its Detection Zone and turns on lights
automatically. It welcomes visitors and may deter intruders.
