ALED 52W INSTALLATION INSTRUCTIONS
Thank you for buying RAB lighting fixtures. Our goal is to design the best quality products to get the job done right. We’d like to hear your comments.
Call the Marketing Department at 888-RAB-1000 or email: [email protected]
®
MOUNTING ALED52 TO POLE
Mount directly to 4” or larger square steel pole. Do not separate
Pole Arm
from
Housing.
1.
Remove
Pole Arm
Cover Plate
by loosening two screws
.
2.
Place
Pole Gasket
between the
Pole Arm
and drilled
Pole
as shown. Line up center hole with center hole in the pole drilling
pattern.
3.
Insert 3/8-16 x 1 1/4”
Bolts
from the
Pole Arm
thru the top hole of the
Pole
and thread into the
Bolster Plate
. Longer 2 1/4”
bolts provided for use with round pole and round pole adaptor. For PAD4 applications use
bolts, nuts, lockwashers
and
washers and tighten inside the PAD4. Do not use
bolster plate
.
4.
Knot wires in pole for strain relief and feed wires from the pole into the
Pole Arm
. Make the necessary wiring connections in
the
Pole Arm.
5.
Install the
Arm Gasket
on to the
Pole Arm Cover Plate
and secure it with the screws. Cover the screws with provided caps.
Install the
Pole Cap
.
Bolster Plate
Housing
Pole Arm
Bolts, Washer and
Lockwasher
Pole Cap
Pole Gasket
Pole Arm Cover
Plate
Arm Gasket
ALED52
Standard (15 Deg)
ALEDC52
Cutoff (7.5 Deg)
ALEDFC52
Full Cutoff (0 Deg)
IMPORTANT
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE
.
RAB fixtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper grounding
is required for safety. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A
PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
WARNING: Make certain power is OFF before installing or maintaining fixture. No user serviceable parts inside.