Eurgle 2.4Ghz 3 Ch LCD Wheel
Digital Programmable Radio Gear
rcps2805004
Join our FREE Membership and accept 10%off Offer!
R2hobbies.com
The system works in between 2.400GHz to 2.4835GHz frequencies that have been divided into 160
frequency points. Each system uses 16 frequencies points and 160 hopping frequency. By using
various switching-on time, frequency hopping and different frequency points, the system can
passively avoid frequency jamming.
The system uses a linear spread of fine paragraph by excess antenna, which covers the entire band
width of the antenna bandwidth range, greatly enhances the efficiency of the system launch and
receiving sensitivity. It greatly improves system stability, and strengthens the passive anti-Jamming
capability of the system.
The system uses low power consumption components, and the receiver chip is extremely sensitive;
the system uses interval signal transmission, thereby reducing the transmission power, and
increasing the operating. Comparatively this system consumes only one tenth of the normal FM
system.
Battery Charging Note
If your transmitter, receiver using a nickel-cadmium, nickel-metal hydride rechargeable battery, you
have to well –check before you use.
If lack of electricity, it could happen those phenomenon like inadequate control or out of control,
resulting accident.
So please charge immediately when the battery lacks of electricity.
If you are using a nickel-cadmium-cadmium, nickel-metal hydride batteries for recharging, please
use our company-dedicated charger.
If the electrical current is too large and it may lead to temperature over-heated and cause fire
burning accident.
Please cut off the power supply immediately after recharging.
Please take out the battery from the transmitter when you are not using it within a period, it is
because the battery may damage the aircraft batteries, thus being exposed.
TRANSMITTER CHARGER
1.
Install the battery to transmitter with correct direction, and cover it.
2.
Connect the charger to the commercial power connector.
3.
Connect the charger to the transmitter Connector.
4.
Cut off the power supply immediately after Recharge completed.
RECEIVER CHARGER
1.
Connect the charger to the commercial power connector.
2.
Connect the Rechargeable receiver with battery charger.
3.
Recharge completed, cut off the power supply immediately.
